Page 1 of 1
Pressure washer in GGDT
Posted: Fri Aug 23, 2013 9:29 am
by fenrir
Hi guys, I'm just wondering what I should plug in GGDT for a pressure washer. The model I have is a M407 MTM. It has a 3/8 inlet and 1/4 outlet (npt) and a gpm of 7.
Posted: Sat Aug 24, 2013 7:12 am
by jackssmirkingrevenge
It's a bit hard to model because of the fact that you're opening the valve manually, so opening time is hard to estimate. Is this for a single shot launcher?
Posted: Sat Aug 24, 2013 2:31 pm
by fenrir
Yes it is. I'm planning to somehow attach a 12 gram co2 cartridge to it and add a barrel. I got the idea from reading about your 9mm smg. Any suggestions?
Posted: Sat Aug 24, 2013 2:51 pm
by tigerblues28
Add a union and make up some burst discs. That's what I would do, and I'm still planning on it once I pick up a job.
Nick
Posted: Sun Aug 25, 2013 12:59 pm
by jackssmirkingrevenge
fenrir wrote:Yes it is. I'm planning to somehow attach a 12 gram co2 cartridge to it and add a barrel. I got the idea from reading about your 9mm smg. Any suggestions?
You could get one of these:
http://www.ebay.com/itm/New-Quick-Chang ... 48559b6fda
Which hooks up to one of these:
http://www.ebay.com/itm/New-CO2-ASA-Ada ... 5af0975a24
then you have to find an adapter that has 1/8 NPT male on one end and whatever your pressure washer handle has on the other.