Page 1 of 1
watermaster 3/4 leeking slowly out the barel
Posted: Tue Mar 27, 2007 7:45 pm
by mopherman
i modded a 3/4 sprink and i have to use a ball valve in front of it to make it seal. the problem is that it doesnt seal compleatly. it lets air out the barel slowly and i can only get a shot off if I work quickly.
thanks
Posted: Tue Mar 27, 2007 8:05 pm
by WOW!!
Can you get a pic of the valve?
And did you take the selonid off of it and seal it?
Posted: Tue Mar 27, 2007 8:06 pm
by pyromaniac
you told me you bought the orbit off amzon?
Posted: Tue Mar 27, 2007 8:08 pm
by mopherman
i left the solenoid on cause i dont have any epoxie on hand.
Posted: Tue Mar 27, 2007 8:09 pm
by mopherman
sorry i meant watermaster
Posted: Tue Mar 27, 2007 10:52 pm
by noname
Take it apart and clean the diaphragm. Put some heavy grease on top of the diaphragm to weight it down.
Posted: Wed Mar 28, 2007 3:48 am
by hi
you need to epoxy up the solenoid hole at the top. That is, assuming that you are planing to modd it.
Posted: Wed Mar 28, 2007 6:49 am
by jrrdw
Could be something on the diaphram, take it apart and check both sides of it, then lube it.
Posted: Thu Mar 29, 2007 6:00 pm
by mopherman
can i just yank the phram?
Posted: Thu Mar 29, 2007 6:06 pm
by noname
What!? You could make your own diahragm.
Posted: Thu Mar 29, 2007 6:08 pm
by mopherman
i cant even make this siaphram work! i just need to know hopw to remove the damn thing.
Posted: Thu Mar 29, 2007 6:45 pm
by mopherman
just cleaned the diaphram. works like a champ