Pressure washer in GGDT

[fenrir]

Hi guys, I'm just wondering what I should plug in GGDT for a pressure washer. The model I have is a M407 MTM. It has a 3/8 inlet and 1/4 outlet (npt) and a gpm of 7.

[jackssmirkingrevenge]

It's a bit hard to model because of the fact that you're opening the valve manually, so opening time is hard to estimate. Is this for a single shot launcher?

[fenrir]

Yes it is. I'm planning to somehow attach a 12 gram co2 cartridge to it and add a barrel. I got the idea from reading about your 9mm smg. Any suggestions?

[tigerblues28]

Add a union and make up some burst discs. That's what I would do, and I'm still planning on it once I pick up a job.

Nick

[jackssmirkingrevenge]

Yes it is. I'm planning to somehow attach a 12 gram co2 cartridge to it and add a barrel. I got the idea from reading about your 9mm smg. Any suggestions?

You could get one of these: http://www.ebay.com/itm/New-Quick-Chang ... 48559b6fda

Which hooks up to one of these: http://www.ebay.com/itm/New-CO2-ASA-Ada ... 5af0975a24

then you have to find an adapter that has 1/8 NPT male on one end and whatever your pressure washer handle has on the other.